5.If the new cluster acts as a recovery cluster for any recovery group, create a monitor package for the new cluster.
Apply the configuration of the new monitor package.
#cmapplyconf -p ccmonpkg.config
6.Restart the monitor package on the recovery cluster.
#cmrunpkg ccmonpkg
7.View the status of the Continentalclusters.
#cmviewconcl
Creating a new Recovery Cluster
After creating a new cluster to replace the failed primary cluster, if the downtime involved in moving the applications back is a concern, then make the newly created cluster as the recovery cluster. It is also assumed that the original recovery cluster has sufficient resources to run all critical applications indefinitely. Do the following to set up the recovery cluster.
•Change the original recovery cluster to the role of primary cluster for all recovery groups.
•Configure the new cluster as a recovery cluster for all those groups.
Configure the new cluster as a standard Serviceguard cluster, and follow the usual procedure to configure the Continentalclusters with the new cluster used as a recovery cluster for all recovery groups.
NOTE: In a multiple recovery pairs scenario, (where more than one primary cluster is configured to share the same recovery cluster), reconfiguration of the recovery cluster must not be done due to the failure of one of the primary clusters.
Creating a new Recovery Cluster 35
