HP Serviceguard Metrocluster # cmapplyconf -v -P sitecontrollerconfigurationfile, Site cc2site1

3.Configure the Site Controller Package in the primary cluster with the RAC MNP stack in primary cluster:

#site cc1_site1

#critical_package <cluster1_RAC_DB_pkg_name>

#managed_package <cluster1_ASM_DG_pkg_name>

NOTE: Do not add any comments after specifying the critical and managed packages.

4.Re-apply the Site Controller Package configuration.

# cmapplyconf -v -P <site_controller_configuration_file>

After applying the Site Controller Package configuration, run the cmviewcl command to view the packages that are configured.

5.Repeat the above steps in the Recovery cluster as well.

Configuring the Site Controller package in the recovery cluster

The site controller package needs to be configured in the recovery cluster. The procedure to configure the Site Controller Package is identical to the procedure in configuring complex workload in Continentalclusters using SADTA. For more information on configuring the Site Controller Package for Oracle RAC database with ASM in SADTA, see “Configuring the Site Controller package in the recovery cluster” (page 52).

Configuring the Site Safety Latch dependencies at the recovery cluster

After the Site Controller Package configuration is applied, the corresponding Site Safety Latch is also configured automatically in the cluster. This section describes the procedure to configure the Site Safety Latch dependencies.

To configure the Site Safety Latch dependencies in the recovery cluster:

1.Add the EMS resource details in ASM DG package configuration file.

RESOURCE_NAME /dts/mcsc/hrdb_sc

RESOURCE_POLLING_INTERVAL 120 RESOURCE_UP_VALUE != DOWN RESOURCE_START automatic

You must apply the modified ASM DG package configuration using the cmapplyconf command .

2.Verify the Site Safety Latch resource configuration at both sites. Run the following command to view the EMS resource details:

#cmviewcl -v –p <ASM_DG_pkg_name>

3.Configure the Site Controller Package in the recovery cluster with the RAC MNP stack in the recovery cluster.

site cc2_site1

critical_package <cluster2_RAC_DB_pkg_name> managed_package <cluster2_ASM_DB_pkg_name>

NOTE: Do not add any comments after specifying the critical and managed packages.

4.Re-apply the Site Controller Package configuration.

#cmapplyconf -v -P <site_controller_configuration_file>

After applying the Site Controller Package configuration, run the cmviewcl command to view the packages that are configured.

Configuring the Site Controller package in the recovery cluster 143