The paper is cut when the print has been completed
By default the printer cuts the paper after the drying time has been completed, see Change the drying time on page 56. You can disable the cutter, see Turn the automatic cutter on and off on page 56.
The cutter does not cut well
By default the printer is set to automatically cut the paper after the drying time has been completed.
If the cutter is turned on but not cutting correctly, check that the cutter rail is clean and clear of any obstacles.
If the cutter is turned off, the Form feed and cut key 
only advances the paper. Use this key to move the print far enough out of the front of the printer, until it is convenient to manually cut with a straight edge or scissors.
The roll is loose on the spindle
The roll may need to be replaced or reloaded. If your roll has a
A strip stays on the output tray and generates jams
If a small piece of paper (200 mm or smaller) has been cut, such as before (if new roll) and after a full-
bleed print or after the Form feed and cut key 
has been pressed, the cut strip remains in the output tray. Only when the printer is not working, reach in the tray and remove the strip.
Paper issues
Recalibrate the paper advance
Accurate paper advance is important to image quality because it is part of controlling the proper placement of dots on the paper. If the paper is not advanced the proper distance between printhead passes, light or dark bands appear in the print and image grain may increase.
The printer is calibrated to advance correctly with all the papers appearing in the front panel. When you select the type of loaded paper, the printer adjusts the rate at which to advance the paper while printing. However, if you are not satisfied with the default calibration of your paper, you may need to recalibrate the rate at which the paper advances. See Troubleshooting
ENWW | The paper is cut when the print has been completed 155 |
