Installation
Installing The Kerberos Server
|
| Installing The Kerberos Server |
|
| If you are migrating your Kerberos database from version 1.0 to the |
|
| new version, version 2.0, create a dump file of the older Kerberos |
|
| database before installing the new version of HP’s Kerberos Server. |
|
| Refer to Chapter 3, “Migration,” on page 41. |
Step | 1. | Insert the software media (tape or disk) in the appropriate drive |
Step | 2. | Type: swinstall |
|
| See the man page on swinstall (1m) for more information on this |
|
| command |
Step | 3. | Click on OK on the “Specify Source” window. |
Step | 4. | Highlight T1417AA in the ‘Software Selection’ dialog, then select ‘Mark |
|
| For Install’ from the ‘Actions’ menu to install all filesets in the |
|
| bundle. |
Step | 5. | When you have marked the product components you want to install, |
|
| select ‘Install (analysis)’ from the ‘Actions’ menu. |
Step | 6. | When you have successfully completed the analysis, click on OK from the |
|
| ‘Analysis’ dialog to load the Kerberos Server filesets. |
If you are migrating your Kerberos database from version 1.0 to version 2.0, the following message is displayed:
The kerberos database dump file needs to be created before you go ahead with this installation. If this is a migration from Kerberos Server Ver 1.0 to Kerberos Server 2.0, refer to the section Migration, in the Installing, Configuring and Administering the Kerberos Server on
The swinstall utility loads the filesets. Estimated time for processing is five minutes.
If the installation is not successful, an error message is displayed. The cause of the failure will appear at the end of /var/adm/sw/swagent.log file.
38 | Chapter 2 |