SmartConnect User’s Guide

Management Network Settings

Use this window to add a defined network through which switch access is allowed through Telnet, SNMP, SSH, or the SmartConnect browser-based interface (BBI). A range of IP addresses is produced when used with a network mask address. Specify an IP address and mask address in dotted-decimal notation.

Note: If you configure the management network without including the switch interfaces, it will cause the Firewall Load Balancing health checks to fail and will create a “Network Down” state on the network.

Table 10-11Management Network Configuration Fields

Field

Description

 

 

Index

Displays the numeric ID of each management network entry.

 

 

Management Network

Configures the IP address of the management network.

Address

 

Management Network Sub- Configures the subnet mask of the management network. net Mask

Bootstrap Protocol Settings

Use this window to configure BOOTP settings.

Table 10-12BOOTP Configuration Fields

Field

Description

 

 

BOOTP State

Globally enable or disable BOOTP relay on the switch.

 

 

BOOTP Server IP Address

Sets the IP address of the BOOTP server.

 

 

Secondary BOOTP Server IP

Sets the IP address of the second BOOTP server (optional).

Address

 

 

 

126 „ Chapter 10: System Settings

BMD00082, February 2009

Page 128
Image 128
IBM Partner Pavilion BMD00082 manual Management Network Settings, Bootstrap Protocol Settings, 12BOOTP Configuration Fields