SmartConnect User’s Guide
4.You can use the default IP addresses provided by the management module, or you can assign a new IP address to the switch through the management module.
You can assign this IP address through one of the following methods:
Manually through the management module
Automatically through the blade server chassis Configuration Wizard
Note – If you change the IP address of the switch, make sure that the switch and the manage- ment module both reside on the same subnet.
In Advanced Configuration > Advanced Setup, enable “Preserve new IP configuration on all switch resets,” to retain the switch’s IP interface when you restore factory defaults. This set- ting preserves the management port’s IP address in the management module’s memory, so you maintain connectivity to the management module after a reset.
You now can start a Telnet session,
5.For HTTPS access, you must enable HTTPS on the switch. For example:
>>/cfg/sys/access/https/access e
For more information about SSH access, refer to “Secure Shell and Secure Copy” on page 78.
66 Chapter 6: Configuring Switch Access | BMD00082, February 2009 |
