JVC GY-HD200E/CHE, GY-HD200U/CHU, GY-HD201E/CHE manual AC Operation, Battery Operation

PREPARATIONS

AC Operation

This device is operable with AC power supply or battery pack.

Use the AC adapter as the AC power supply.

1.After making sure that the power switches of this device and of the AC adapter are set to OFF, connect the DC cable to the DC OUTPUT connector of the AC adapter and the DC INPUT connector of this device as shown in the illustration.

•To lessen the amount of unnecessary radio waves emitted, attach a provided Clamp filter near both ends of the DC cable as shown in the diagram.

	VIDEO
	CH2-AUDIO OUT-CH1
Clamp filter	IEEE 1394
	DC INPUT
DC cable

DC OUTPUT

Clamp filter

AC adapter

2.Press the POWER switch of this device to ON. Power is supplied to the VTR section and the camera.

CAUTION

•Do not remove or connect the DC cable while recording is being performed.

•Do not use any power source with large fluctuations in the power source voltage, power sources generating noise, such as ripples or power sources with lower volt- age.

Charging the Built-in Battery

The built-in, rechargeable backup battery retains the date and time and the time code data.

The built-in battery is constantly being charge whenever this device is connected to a power supply, but it gradually dis- charges while this device is disconnected from a power sup- ply. The battery will be fully discharged when this device is not used for about three months, in which case the set date and time and time code data are reset.

In this case, recharge the built-in battery and then set the date and time and time code data again.

However, it is possible to use this device even if the built-in battery is discharged but the date and time and time code data cannot be recorded.

How to charge the built-in battery

1.Connect the AC adapter to this device and an AC outlet or mount a charged battery on this device.

2.Set the POWER switch on this device to “ON” or “OFF” (charging takes places with the POWER switch set to either of the positions).

3.Leave the equipment in this condition for about 4 hours.

•The built-in battery will remain charged for about 3 months after being charged for about 4 hours.

Battery Operation

The attachable battery varies depending on location. Recommended batteries

U model: Dionic 90 (Anton Bauer)

E model: Endura-7 (IDX)

CAUTION

Use only the recommended batteries.

If a heavy battery is used, the battery may fall out depend- ing on the way the HD camera recorder is used.

„GY-HD200U

Use an Anton Bauer battery.

Attaching the Battery

1.Align the battery guide pins (three places) with the bat- tery adapter guide holes and insert straight. Battery will not be properly attached if guide pins are not straight.

Cassette cover	Guide	Guide pins
side panel	holes (×3)
Release lever

Battery pack (trim pack)

LCD screen side panel

2.Slide the battery towards the Cassette cover side panel until it clicks.

• The battery is attached.

Removing the Battery

Slide the battery towards you (LCD screen side panel) while holding down the release lever, and pull away from the device to remove the battery.

Release lever

Battery

„GY-HD200E/GY-HD201E

Use an IDX (Endura) battery.

Attaching the Battery

1.Face the battery terminals down and align the battery V- mount with the battery adapter V-mount attachment.

V-mountV-mount attachment

2.Slide the battery down until it clicks and locks.

• The battery is attached.

Removing the Battery

Slide the battery up while holding down the lock release but- ton to remove the battery.

Release button

Battery

36 37