HOME
Maintenance & Supplies
Loading Paper (continued)
Loading Tabbed Sheets in LCT (LT-402/LT-412)
Load offset tabbed sheets so that the tab extensions are on the right at the rear (not front) of the tray. The tab extension width should be 0.5" (12.5 mm) or less.
When loading tabbed sheets in the tray, be sure to specify the paper type as TAB in the Key Operator mode; otherwise mishandled paper may occur.
The top sheet is designated face up as the first tab of the finished set. Subsequent offset tab sheets follow in sequence.
Front |
Front
Example: 3 Tabbed sheets loaded in position for one finished set. | |||
Rear |
|
| 1st TAB |
|
|
| |
|
| 1st TAB |
|
|
| Section 1 | 2nd TAB |
| Section 1 | Introduction | |
|
|
| |
Printed | Introduction | 2nd TAB |
|
| 3rd TAB | ||
set |
|
| |
|
| 3rd TAB |
|
|
| ONE FINISHED SET | |
Example: 9 Tabbed sheets loaded in position for 3 finished sets.
Rear | 1st TAB | 2nd TAB |
|
| 1st TAB | 2nd TAB |
|
|
|
| Section 1 | Section 1 | |
|
| Section 1 | ||
|
| Introduction | Introduction | Introduction |
Printed | Section 1 |
|
|
|
Introduction |
|
|
| |
|
|
|
| |
set |
|
|
|
|
3rd TAB | 3rd TAB | |
THREE FINISHED SETS | ||
|
Maintenance & Supplies
