Kyocera DP-3600 manual RS-422A interface

Serial (RS-232C/RS-422A) Interface

RS-422A interface

The serial interface of this printer was set to RS-232C mode before leaving the factory. However, by changing the jumper connector on the main circuit board, the interface can be changed to RS-422A mode.

In RS-232C mode, the printer can be connected to a personal computer

(or similar device) equipped with an RS-232C serial interface. (The serial interface is set to RS-232C before leaving the factory.)

In RS-422A mode, the printer can be connected to a personal computer (or similar device) equipped with an RS-422A serial interface.

Note______________________________________________________________________

The changing of the main circuit board jumper connector should be carried out only by an authorized dealer or a certified technician. We shall not be liable for damage due to improper changing of this main circuit board jumper connector.

Note______________________________________________________________________

The following instructions are intended for the technician only.

Note on Handling the Main Circuit Board

Before touching the main circuit board, touch a water pipe or other large metal object to discharge yourself of static electricity. While doing the work, it is recommended that you wear an antistatic wrist strap.

C-9