|
| Indicators and Messages |
|
|
|
|
|
|
| Message | Corrective Action |
| MEMORYCARD err ## | 11: The memory card is full of data items. The number of data items which |
| Press CONTINUE | can be written on the memory card is limited to 127. Pressing the CANCEL |
|
| key will restore the message Ready in the message display. |
|
| 13: This is a logical error. Try substituting another flash memory card. |
|
| 15: The flash memory card in question is not supported by this printer. |
|
| 17: The flash memory card cannot be written due to insufficient printer |
|
| memory. Either delete unnecessary macros and/or fonts stored in the printer, |
|
| or expand the printer's available memory. |
|
| 18: This is a write error. Try substituting another flash memory card. |
|
| (Error codes 13 through 18 apply only to a flash memory card.) |
|
|
|
| >Read fonts ? | The font cannot be read due to insufficient memory. |
| Failed | A download font could not be loaded into printer memory due to insufficient |
|
| |
|
| available printer memory. Either remove unnecessary download fonts and/or |
|
| macros or expand the printer's memory. |
| I/F occupied | The interface selected is currently being used. |
|
| The interface is secured while the interface name displayed in the message |
|
| display is flashing even if the printer is in the ready state. How long this takes |
|
| depends on the interface release timeout (FRPO J2) setting. |
|
| This message appears, and then the ATTENTION indicator lights, when an |
|
| attempt is made to select a secured interface from the control panel or when |
|
| an attempt is made to perform memory card operations while the interface |
|
| indicator is flashing. |
|
| Repeat operations after releasing the interface. |
|
|
|
|
| (Continued on next page) |
Page 181
Image 181
