Linksys SPA9000 manual Voice Provisioning Screen Firmware Upgrade

IP Telephony System

Profile Rule B, C, and D. Enter profile rules B, C, and D.

Log Resync Request Msg. This script defines the message sent to the configured syslog server whenever the System attempts to resync with the provisioning server. Enter the appropriate script. The default is $PN $MAC -- Requesting resync $SCHEME://$SERVIP:$PORT$PATH.

Log Resync Success Msg. This script defines the message sent to the configured syslog server whenever the System successfully completes a resync with the provisioning server. Enter the appropriate script. The default is $PN $MAC -- Successful resync $SCHEME://$SERVIP:$PORT$PATH.

Log Resync Failure Msg. This script defines the message sent to the configured syslog server whenever the System fails to complete a resync with the provisioning server. Enter the appropriate script. The default is $PN $MAC -- Resync failed: $ERR.

Report Rule. Enter the report rule.

Firmware Upgrade

Upgrade Enable. The firmware profile must be requested by the System and cannot be pushed from an upgrade server, although a service provider can effectively push a new firmware load by remotely triggering the request operation via the configuration file. To enable the upgrade feature, select yes. Otherwise, select no. The default is yes.

Upgrade Error Retry Delay. If an upgrade attempt fails, the System will retry after a period of time. Enter the period of time in seconds. The default is 3600.

Downgrade Rev Limit. Enter the downgrade firmware revision limit.

Upgrade Rule. Enter the upgrade rule.

Log Upgrade Request Msg. This script defines the message sent to the configured syslog server whenever the System attempts an upgrade from the upgrade server. Enter the appropriate script. The default is $PN $MAC -- Requesting upgrade $SCHEME://$SERVIP:$PORT$PATH.

Log Upgrade Success Msg. This script defines the message sent to the configured syslog server whenever the System successfully completes an upgrade from the upgrade server. Enter the appropriate script. The default is $PN $MAC -- successful upgrade $SCHEME://$SERVIP:$PORT$PATH -- $ERR.

Log Upgrade Failure Msg. This script defines the message sent to the configured syslog server whenever the System fails to complete an upgrade from the upgrade server. Enter the appropriate script. The default is $PN $MAC -- Upgrade failed $ERR.

Chapter 6: Using the Web-based Utility

The Voice Tab

Figure 6-24: Voice - Provisioning Screen - Firmware

Upgrade

firmware: the programming code that runs a networking device.

upgrade: to replace existing software or firmware with a newer version.

46

VoIPon Solutions www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0) 1245 600560