8. Printing Procedures (Special prints)

SET

B Press the SET button.

, The source image (image from the input signal) is displayed.

1Storing images in memory / Printing the images

1Store the images to be printed in memory.

, Refer to 1 MULTI PRINT or 2 PHOTO PRINT for storing images in memory.

2Press the PRINT button.

,The set SEPARATE images are printed.

Note :

,The distance between images in multi-print is different between on the monitor and the printed image.

,The image size changes according to the “SIZE” in “6. SYSTEM MENU”.

When the images of different size are memorized in one page, the margin is determined according to the largest width of the image in the page.

4STROBE PRINTS

1OPERATION

1Selecting FIELD or FRAME

1Setting STROBE function

1Press the MENU button. Then press the UP or DOWN button to select “3. ADDITIONAL PUSH [ ]”.

2Press the RIGHT button to select “3. ADDITIONAL”.

3Press the UP button to select “STROBE : OFF”

4 Press the RIGHT

button to select “STROBE : 1/13 ....

1hr”.

,Each time the RIGHT or LEFT button is pressed, the interval of image memorization is switched.

,The interval of memorization can be set as follows:

, 1/13 sec

• 1/5 sec • 1/2.5 sec •

1 sec • 2 sec • 5sec • 10 sec • 30 sec

every second

,

1 min •

2 min • 5min • 10min

• 30 min

every minute

,

1hr

 

every hour

,Images can not be memorized during printing while images are fully stored in memory page.

When the interval of the strobe time is a value lower than the automatic capture and print time interval, the printer will not be able to the image because print time is longer than strobe time. Adjust strobe time by selecting a higher value.

(Example : interval of 10 seconds or less in FIELD mode and interval of 30 seconds or less in FRAME mode)

76

Page 77
Image 77
Mitsubishi Electronics CP700E operation manual Strobe Prints, 1Storing images in memory / Printing the images