8. Printing Procedures (Special prints)
1Displaying the source image (image from the input signal)
SET
1Press the SET 
button.
,“CHANGE : OK/CANCEL” is selected.
,When changing the setting, select “CANCEL”.
SET
2Press the SET 
button.
, The MAIN MENU is displayed.
SET
3Press the SET 
button.
,“SAVE PRG 1/2/3” is selected.
,This menu is used to store the setting in any one of 3 programs (1, 2 or 3).
4Press the RIGHT 
or LEFT 
button to select the program number 1, 2 or 3 to store the setting.
,The setting will be overlaid. In case of keeping the stored program, do not select the program No. in which the setting is stored.
SET
5 Press the SET 
button.
, The source image (image from the input signal) is displayed.
1Storing images in memory
1Press the DISPLAY button to display the set conditions.
2Press the FIELD/FRAME button on the remote control to select FIELD or FRAME.
3Press the MONITOR button and select the source image (“LIVE” is displayed on the monitor.) to display the image to be stored in memory.
4Press the MEMORY button.
,The set strobe memory starts.
,When the strobe memory is set on
,To store the images in strobe memory again while “MEM&STOP” is set to ON at
The strobe images are stored in the 2nd page.
,When “MODE” is set to “SAME”, the images are stored in [A B] or [A B C D] repeatedly.
When “MODE” is set to “DIFF”, “IMAGES” to “4” and FIELD mode, 4 images are stored in [A] or [B] and then image memorization stops.
Images can be stored in the other memory page by pressing the MEMORY PAGE button.
When “MODE” is set to “DIFF” and “IMAGES” to “16”, [A B] and [A B C D] are not indicated. The images can be stored in one memory page.
After storing 16 images in memory, image memorization stops.
When pressing the MEMORY button again, images are stored in memory again.
78
