4. Connection with external equipment (RS-232C Interface)
Setting BAUD RATE
1 Press the DOWN 
or UP 
shift buttons to select “BAUD RATE”.
The set baud rate, for example, “9600” , is displayed.
Press the RIGHT 
or LEFT 
SHIFT button to select “1200” , “2400” , “4800”or “9600”Bit/Sec) .
SET
2Press the SET 
button.
,“CHANGE : OK” is selected.
,Press the RIGHT 
or LEFT 
shift button to select “OK” or “CANCEL” .
SET
3Select “OK” , then, press the SET 
button.
,“Memory SW Main Menu” is displayed.
SET
4Press the SET 
button.
, “CHANGE : OK” is selected.
SET
5Select “OK”, then, press the SET 
button.
, The source image (input signal from the equipment connected) is displayed.
S y s t e m S e t M e n u
B A U D R A T E : 9 6 0 0
S y s t e m S e t M e n u
C H A N G E : O K
M e m o r y S W M a i n M e n u
5 . S Y S T E M S E T : P U S H [ > ]
0The setting of BAUD RATE is completed.
Setting the RS-232C COMMAND TYPE
Select “A” or “B” according to the equipment connected.
1Press the DOWN 
or UP 
buttons to select “COMMAND TYPE” .
Press the RIGHT 
or LEFT 
SHIFT button to select “A” or “B”.
SET
2Press the SET 
button.
,“CHANGE : OK” is selected.
,Press the RIGHT 
or LEFT 
button to select “OK” or “CANCEL” .
SET
3Select “OK” , then, press the SET 
button.
, “Memory SW Main Menu” is displayed.
S y s t e m S e t M e n u
C O M M A N D T Y P E : A
S y s t e m S e t M e n u
C H A N G E : O K
M e m o r y S W M a i n M e n u
5 . S Y S T E M S E T : P U S H [ > ]
20
