NEC 2000 IVS manual Switch Settings, B channel status

PN-2CSIA (CSI)

		Lamp Indications
LAMP NAME	COLOR		FUNCTION
		B channel status
		ON	: B0 channel of the No. 1 circuit is in use.
B10	Red	OFF	: B0 channel of the No. 1 circuit is in idle.
		Flash (60 IPM)	: ZT is not connected to the No. 1 circuit.
			ZT is in make-busy status.
B03	Red	Not used (Flash[60 IMP])
		B channel status
		ON	: B2 channel of the No. 0 circuit is in use.
B02	Red	OFF	: B2 channel of the No. 0 circuit is in idle.
		Flash (60 IPM)	: ZT is not connected to the No. 0 circuit.
			ZT is in make-busy status.
		B channel status
		ON	: B1 channel of the No. 0 circuit is in use.
B01	Red	OFF	: B1 channel of the No. 0 circuit is in idle.
		Flash (60 IPM)	: ZT is not connected to the No. 0 circuit.
			ZT is in make-busy status.
		B channel status
		ON	: B0 channel of the No. 0 circuit is in use.
B00	Red	OFF	: B0 channel of the No. 0 circuit is in idle.
		Flash (60 IPM)	: ZT is not connected to the No. 0 circuit.
			ZT is in make-busy status.

3.Switch Settings

Switch Settings

SWITCH NAME	SWITCH	SETTING	FUNCTION	CHECK
	NUMBER	POSITION
DL0 (Rotary SW)			For normal operation
		0
	0 ~ F
		1 ~ F	Not used
Note
DL1 (Rotary SW)			For normal operation
		0
	0 ~ F
		1 ~ F	Not used
Note

The figure in the SWITCH NAME column and the position in in the SETTING POSITION col- umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and , the setting of the switch varies with the system concerned.

Note: Set the groove on the switch knob to the intended switch position.

CHAPTER 4 ND-45504 (E)

Page 134

Revision 2.0