NEC 2000 IVS manual Switch Settings, SW0 Rotary SW, card is to be mounted

				PN-BS01-B (BS01)
(3) Switch Settings		Switch Settings
SWITCH NAME	SWITCH	SETTING	FUNCTION	CHECK
	NUMBER	POSITION
SW0 (Rotary SW)		Set this rotary switch to match the location in which this circuit
		card is to be mounted.
	0 - 3	0	For mounting this card in PIM1
		1	For mounting this card in PIM2, 3

Note 1

2For mounting this card in PIM4, 5

3For mounting this card in PIM6, 7

	4 - F	Not used
MB (Toggle SW)		For make-busy
	ON	UP

For normal operation

DOWN

Note 2

The figure in the SWITCH NAME column and the position in in the SETTING POSITION col- umn indicate the standard setting of the switch. When the switch is not set as shown by the figure and , the setting of the switch varies with the system concerned.

Note 1: Set the groove on the switch knob to the desired switch position.

Note 2: When the power is on, flip the MB switch to ON (UP position) before plugging/unplugging the circuit card.

ND-45504 (E)CHAPTER 4

Page 27

Revision 2.0