2.INSTALLATION CONDITIONS FOR CONTROL CIRCUIT CARDS
2.1 PN-CP00/PN-CP00-B/PN-CP00-C (MP)
Mount the PN-CP00/PN-CP00-B/PN-CP00-C in the MP slot of PIM0.
2.2 PN-CP01 (FP)
1.The PN-CP01 is required only if any of the following is true.
•More than one PIM is used.
•A PN-2DLCC is used.
•A PN-AP01 is used.
•OAI, ACD, No. 7 CCIS or ISDN is used.
2.When the system is equipped with two PIMs, mount one PN-CP01 in the FP slot of PIM0. When the sys- tem is equipped with more than two PIMs--depending on the number of additional PIMs used--mount one PN-CP01 in the FP slot of PIM0 and one PN-CP01 in the MP/FP slot of PIM2, PIM4 and PIM6.
Figure 3-2 MP/FP Card Mounting Slots
ND-45504 (E) | CHAPTER 3 |
Addendum-002 | Page 11 |
OCTOBER, 1998 | Revision 2.2 |
