NEC 2000 IVS manual For normal operation SW1 Dip SW D15

PN-CC01 (ETHER)

3.Switch Settings

Switch Settings

	SWITCH		SWITCH	SETTING			FUNCTION			CHECK
	NAME		NUMBER	POSITION
MB (Toggle SW)				UP	For make-busy
		ON
				DOWN	For normal operation
Note 1
SW1 (Dip SW)			1 (D15)	ON
								ON: 0 OFF: 1
			2 (D14)	ON
ON	1 2 3 4 5 6 7 8					MAC ADDRESS		SWITCH SETTING
			3 (D13)	ON
						00004CA4 X X X X
			4 (D12)	OFF
						(HEX)
Note 2			5 (D11)	ON				SW1-1 (D15)	ON/OFF
				OFF		Fixed		SW1-2 (D14)	ON/OFF
								SW1-3 (D13)	ON/OFF
			6 (D10)	ON
								SW1-4 (D12)	ON/OFF
				OFF
			7 (D9)	ON
								SW1-5 (D11)	ON/OFF
				OFF
								SW1-6 (D10)	ON/OFF
			8 (D8)	ON
								SW1-7 (D9)	ON/OFF
				OFF
								SW1-8 (D8)	ON/OFF
SW2 (Dip SW)			1 (D7)	ON
				OFF				SW2-1 (D7)	ON/OFF
ON	1 2 3 4 5 6 7 8
			2 (D6)	ON
								SW2-2 (D6)	ON/OFF
				OFF
								SW2-3 (D5)	ON/OFF
			3 (D5)	ON				SW2-4 (D4)	ON/OFF
Note 2
				OFF
			4 (D4)	ON				SW2-5 (D3)	ON/OFF
				OFF				SW2-6 (D2)	ON/OFF
			5 (D3)	ON				SW2-7 (D1)	ON/OFF
								SW2-8 (D0)	ON/OFF
				OFF
			6 (D2)	ON
				OFF
			7 (D1)	ON
				OFF
			8 (D0)	ON
				OFF

Note 1: When the power is on, set the MB switch to ON (UP position) before plugging/unplugging the Circuit card.

Note 2: Each equipment must have a unique MAC address to distinguish between systems. Therefore, when more than one PBX is installed in the same network, assign the lower 4 digits of the following MAC address by SW1 and SW2 to prevent duplicate addresses.

00004CA4 XX XX (HEX)
	According to the switch setting of SW2 (D7-D0)
	According to the switch setting of SW1 (D15-D8)
Fixed
	ND-45504 (E)	CHAPTER 4
	Addendum-001	Page 68-3
	JULY, 1998	Revision 2.1