NEC 2000 IVS manual Switch Settings, PN-24DTA-ADTI

PN-24DTA-A (DTI)

(3) Switch Settings

Switch Settings

SWITCH		SWITCH	SETTING							FUNCTION						CHECK
	NAME	NUMBER	POSITION
	SENS	4 ~ F	Set the switch to match the AP Number (04 ~ 15) to be set by CM05.
(Rotary SW)
		AP NO.	04	05	06	07	08	09	10		11	12	13	14	15
		SW NO.	4	5	6	7	8	9	A		B	C	D	E	F

Note 1	0 ~ 3	Not used
MB (Toggle SW)
ON		UP	For make-busy
		DOWN	For normal operation
Note 2
		ON	Clock signal from a master office is sent to the PLO 0 in-
			put on the MP card.
	1
			Clock signal from a master office is not sent to the PLO
		OFF
			0 input on the MP card.
SW		ON	Clock signal from a master office is sent to the PLO 1 in-
			put on the MP card.
(Piano Key SW)	2
			Clock signal from a master office is not sent to the PLO
		OFF
			1 input on the MP card.
OFF		ON	Remote loop-back
	3
8			For normal operation
		OFF
7
			Local loop-back (AIS send)
6	4	ON
5		OFF	For normal operation
4
			Set the equalizer according to the cable length between
3	5	ON
2		OFF	the PBX and the MDF.
1
	6	ON	SW-5 SW-6		SW-7	CABLE LENGTH
ON		OFF	ON	ON	ON	0 - 40 m ( 0 - 131.2 ft.)
			ON	ON	OFF	40 - 80 m (131.2 - 262.5 ft.)
		ON	ON	OFF	ON	80 - 120 m (262.5 - 394 ft.)
			ON	OFF	OFF	120 - 160 m (394 - 525 ft.)
	7
		OFF	OFF	ON	ON	160 - 200 m (525 - 656 ft.)
			OFF	OFF	OFF	Signal is not sent
	8	ON	Always set to ON

CHAPTER 4 ND-45504 (E)

Page 76

Revision 2.0