NEC 2000 IVS manual Installation Conditions for Application Circuit Cards

3.INSTALLATION CONDITIONS FOR APPLICATION CIRCUIT CARDS

1.When the system is equipped with only one PIM:

•An application circuit card can be mounted in the AP0 through AP6, and AP8 slots.

•An application circuit card can not be mounted in the AP6 slot if any of the following is true.

–A PN-2DLCC is used.

–A PN-AP01 is used.

–OAI, ACD, No. 7 CCIS or ISDN is used.

–The PN-CP02s are used.

2.When the system is equipped with more than one PIM:

•An application circuit card can be mounted in the AP0 through AP5 slots of PIM0/PIM(D)0.

•An application circuit card can be mounted in the AP0 through AP6 slots of PIM2, 4 and 6.

•An application circuit card can be mounted in the AP0 through AP7 slots of PIM1, 3, 5 and 7.

•If the system is equipped with CP02s, the AP5 and AP6 slot of PIM(H)0 cannot be used for an appli- cation circuit card.

Note 1: The application circuit card (PN-24DTA/PN-24DTA-A/PN-30DTC/PN-30DTC-A) cannot be mounted in either the AP7 or the AP8 slot since neither of these slots have a connection to the MDF through the Back Wiring Board.

Note 2: The application circuit card (PN-24DTA/PN-24DTA-A/PN-30DTC/PN-30DTC-A [DT10, DT11] which receives a clock signal must be mounted in the AP0 through AP5 slots of PIM0/PIM(H)0.

Note 3: The application circuit card (PN-CK00) must be mounted in the AP0 through AP6 slots of PIM0/ PIM(H)0.

Note 4: The application circuit card (PN-CC00/PN-CC01) can be mounted in any one of the LT slots or the AP slots.

PN-CC00 card needs two LT/AP slots per one card.

Note 5: The application circuit card (PN-CC00/PN-CC01) should be mounted in a LT/AP slot that adjoins an AP slot for the PN-AP01 card because the cable (48-TW0.3 CONN CA) is connected between the PN- CC00/PN-CC01 card and the PN-AP01 card.

CHAPTER 3	ND-45504 (E)
Page 14	Addendum-001
Revision 2.1	JULY, 1998