REPLACING THE FUSER OIL BOTTLE
Order Number 20-212
1.Turn the printer off and allow it to cool (A).
WARNING! The Fuser Unit area may be very hot.
2.Open the Top Cover (B).
3.Open the Lock Tabs (C).
4.Remove the used Fuser Oil Bottle and discard it (D).
note: Hold a piece of paper under the used Fuser Oil Bottle while removing it to avoid drips in the printer.
AB
5.Insert the new Fuser Oil Bottle, cap side down. Make sure the tab of the bottle is on the right (E). The label will face the front of the printer.
6.Close the Lock Tabs and the Top Cover (F).
7.The Operator Panel will inform you when the Fuser Oil is getting low again.
C
DE
F
