INSTALLING THE FUSER
COMPONENTS
Follow the steps below to install the Fuser Oil bottle and the Fuser Cleaning Roller:
1.Open the Top Cover of the printer (A).
2.Make sure the Lock Tabs are in the open position (B).
3.Remove the orange Tension Release Pins from the ends of the Fuser Rollers. Open the Pressure Release Tabs and pull the pins up and out (C).
note: You may have to pull hard to remove these.
4.Remove the Fuser Oil Bottle from its plastic bag and set into place with the shunt valve down and the labeled side facing the front of the printer (D). The tab on the bottle should face right when viewed from the printer’s front. Place in front of the Lock Tabs.
5.Remove the Fuser Cleaning Roller from its plastic bag and set into place with the exposed part of the roller facing the front of the printer (E). The extra tab should be on the left. Place in back of the Lock Tabs over the Fuser Rollers.
6.Turn the Lock Tabs to the closed position holding the Fuser Oil Bottle and Fuser Cleaning Roller in place (F).
7.Close the Top Cover of the printer.
GETTING STARTED
|
| Lock |
|
|
| Tabs Open | Tension Release Pins |
A | B | C | D |
Save theTension Release Pins and along with all packing materials!
Lock
Tabs Closed
EFG
Installing the Fuser Components | 17 |
