WAN and System Configuration 8-21

If Must Match a Defined Profile is set to No, then an IPX Enabled item is visible. Toggling this item to Yes or No (the default) controls whether or not IPX will be supported on the communication link. If IPX Enabled is set to Yes, an IPX Parameters item becomes visible. If you select IPX Parameters, the IPX Parameters screen appears (see “IPX parameters (default profile) screen” on page 8-22). This screen allows you to configure various IPX parameters for connections established without an explicitly configured connection profile.

IP parameters (default profile) screen

The IP Parameters (Default Profile) screen allows you to configure various IP parameters for connections established without an explicitly configured connection profile:

IP Parameters (Default Profile)

Address Translation Enabled:

No

Filter Set (Firewall)...

 

Remove Filter Set

 

Receive RIP:

Both

Transmit RIP:

Off

Return/Enter accepts * Tab toggles * ESC cancels.

The Netopia R5000 Series Router always acts as a DHCP client on the communication link when using a Default Profile. The DHCP server will supply a local IP address and subnet mask. For a communication link, Network Address Translation (NAT) is enabled by default in the Default Profile. For details on setting up IP Parameters see “IP Setup and Network Address Translation” on page 9-1.

Page 83
Image 83
Netopia R5100, R5300, R5200 manual IP parameters default profile screen