Chapter 3 Bulk Load Command 217
The CONFIG_TRAP command is used to configure which conditions will cause traps.
COMMAND: CONFIG_TRAP
TRAP_DESCRIPTION: [Trap Description - Required]
TRAP_INTERVAL: [Time between trap checks (hh:mm:ss)]
TRAP_ENABLE: [Enable SNMP Trap - Default:Enable]
END
DHCP
Three bulk load commands are used to configure DHCP:
•CONFIG_REMOTE_POOL
•CONFIG_DHCP
•DELETE_DHCP
The CONFIG_REMOTE_POOL command is used to set the type of remote pool used by the switch, either DHCP or Address Pools.
COMMAND: CONFIG_REMOTE_POOL
POOL_TYPE: [Pool type to use {DHCP/Address Pool} - Required]
END
The CONFIG_DHCP command is used to setup the DHCP servers on the switch.
COMMAND: CONFIG_DHCP
DHCP_TYPE: [DHCP servers to use {Any/Specified}]
DHCP_IP: [DHCP server IP address - Required if DHCP_SERVER is specified]
DHCP_SERVER: [Specified DHCP server to modify {Primary/ Secondary/Tertiary} - Default:Primary]
Reference for the Contivity VPN Switch Command Line Interface
