56 / Programming
To be accepted, the Startup code must be entered no later than 15 minutes after the Norstar system has been powered up. (If 15 minutes have elapsed since you powered up the system, turn system power off and on, to prepare for the Startup process.)
2.Enter the Installer password. The default is Ç؈ÏÈÌwhich is the same as
¤flfl‹››.
Tip - The Installer password shown is the default normally used for Startup. For a system which has already been programmed, the Installer password might have been changed in programming and recorded in the Programming Record.
Changing the default template
After entering the Startup access code and Installer password the display shows Reset memory?.
1.Press YES to select a default template. The display shows the current template.
2.Press CHANGE to choose the appropriate template.
Changing template resets programming.
If you change your system template, your programming will be reset.
Entering programming
After performing Startup, use programming to change default settings as required.
Headings and subheadings in programming help you to keep track of where you are.
P0881594 Issue 01 |