Troubleshooting / 91
Replacing a Base Station
To replace a Base Station, you do not have to power down the ICS. When you replace a Base Station, no portable registration information is lost. After a short boot sequence, the Base Station should be functioning normally.
(U.S. only) If you are relocating a Base Station, call the Northern Telecom Customer Response Center at
Taking a Base Station out of service causes radio coverage to degrade.
To replace a Base Station, follow these steps:
1.If the Base Station is powered locally, unplug the power supply from the AC outlet and unplug the power supply connector from the Base Station
2.Remove the cover from the Base Station.
3.If an external antenna is installed, unplug its coaxial cable from the Base Station.
4.Unplug the teledapt cable from the Base Station.
5.While holding the Base Station (to prevent it from falling), apply upward pressure to the Base Station.
6.Lift the Base Station away from the bracket.
7.Carefully install the new Base Station onto the bracket.
8.Gently press down to snap it into position.
9.Reconnect the teledapt cable to the Base Station connector.
P0881594 Issue 01 |
