Nortel Networks NN44200-313 Defining CallPilot in the customer data block LD, Step Action

20CallPilot resource configuration

Prompt		Response	Notes
CSQI		xxx	Enter the number of CallPilot
			DS0 channels multiplied by 2.
			For example, if there are 24
			DS0 channels, enter 48.
CSQO		xxx	Enter the number of CallPilot
			DS0 channels multiplied by 2.
			For example, if there are 24
			DS0 channels, enter 48.
4	To exit the overlay, enter ****.
		—End—

Defining CallPilot in the customer data block (LD 15)

Tech tip: To view current system parameters, go to LD 21 and enter PRT at the REQ prompt, and then CDB and the appropriate customer number. The result is a list of all the current information in the Customer Data Block. Use the capture text function in hyperterminal to save a text file of the output.

Step Action

1Connect to the PBX.

2Enter LD 15.

3Enter the appropriate values as described in the following table to add Call Park Allowed and Message Center Included. For prompts not listed in the following table, press Enter to accept the default.

Table 5

LD 15 - Configuring Call Park Allowed and Message Center Included

Prompt	Response	Notes
REQ	CHG
TYPE	ftr
CUST	xx	Customer number for CallPilot.
OPT	CPA MCI
IDEF	YES	If Call Forward by Call Type
	NO	(CFCT) is enabled on the CS
		1000 or M1 switch, enter YES.
		Otherwise, enter NO.

Nortel CallPilot

Quickstart Guide

NN44200-313 01.02 Standard

5.019 May 2008

Copyright © 2007-2008, Nortel Networks