Nortel Networks NN44200-313 quick start Installing cables and grounds, Step Action

Installing cables and grounds 43

6Set the SCSI ID on the tape drive to 6.

7Install the monitor, keyboard, and mouse in the same location as the server.

If you are using a KVM-type box, ensure that you have visual contact with the LEDs on the CallPilot server.

8Plug the keyboard and mouse cables into the PS/2 connectors on the rear panel according to the labels.

9Plug the monitor into the video connector on the rear panel. Tighten screws on the connector.

10Install the USB dongle into USB port 0. Ensure that the feature key is in place.

—End—

Installing cables and grounds

Perform the following procedure to install cables and grounds for the

CallPilot server.

This procedure assumes that the cable and RJ45 are terminated properly according to IEEE 802 Ethernet standards and are of sufficient length. This procedure does not cover Ethernet cables of customized length.

Step Action

1Install and connect the ELAN Ethernet cable to the NIC 2 connector labeled on the back of the server from the ELAN hub or Ethernet switch.

Or, use an Ethernet cross-over cable to connect directly to the CS 1000 or M1 switch. If you use this method, no device other than CallPilot can connect to the ELAN subnet.

Note: Connect the CS 1000 or M1 switch ELAN to the same subnet as the CallPilot server ELAN.

2Install and connect the Ethernet cable for the Nortel server subnet to the NIC 1 connector labeled on the back of the server from the Nortel server subnet hub or Ethernet switch.

Not all sites require a Nortel server subnet; this subnet is used for the following features: Desktop Messaging, CallPilot Reporter, My CallPilot, CallPilot Manager remote access, and Application Builder.

Note: Leave the Ethernet cable for the Nortel server subnet unplugged on the server side until antivirus software is installed on the server.

Nortel CallPilot

Quickstart Guide

NN44200-313 01.02 Standard

5.019 May 2008

Copyright © 2007-2008, Nortel Networks