Nortel Networks NN44200-313 Creating a phantom DN, Step Action, Appendix Configuring phantom DNs

64Appendix Configuring phantom DNs

2Enter LD 97.

3At the REQ prompt, enter CHG.

4At the TYPE prompt, enter SUPL.

5At the SUPL prompt, enter xxxx, where xxxx is the loop number, prefixed with N to designate the loop as a phantom loop, or with V to designate a virtual loop.

For Large Systems, xxxx = N0–N156 in multiples of 4. For Small Systems, xxxx = N96 - N112 in multiples of 4.

6To exit the overlay, enter ****.

—End—

Creating a phantom DN

Step Action

1Connect to the PBX.

2Enter LD 10.

3Enter the appropriate values as described in the following table to modify the system parameters. For prompts not listed in the following table, press Enter to accept the default.

Table 19

LD 10 - Creating a phantom DN

Prompt	Response	Notes
REQ	NEW
TYPE	500
TN	aaa.bbb.ccc.ddd	Terminal number, where aaa =
		loop, bbb = shelf, ccc = card,
		and ddd = unit.
CDEN	xx	Card density supported by the
		loop, where xx = DD for double
		density, or 4D for quadruple
		density.
DN	xxxx	DN for CallPilot.

Nortel CallPilot

Quickstart Guide

NN44200-313 01.02 Standard

5.019 May 2008

Copyright © 2007-2008, Nortel Networks