Nortel Networks NN44200-313 quick start Enabling card slots LD

		Enabling card slots (LD 32) 29
Prompt	Response	Notes
KEY	0 SCR xxxx	Where xxxx is the line number
		of the telephone. This is the
		number dialled or the line
		selected when the user makes
		a call from the telephone.
		For example:
		4710
KEY	16 MWK xxxx	Where xxxx is the CDN of the
		CallPilot system.
		For example:
		4300

4Repeat step 3 for each telephone to be configured. Configure at least two telephones for testing purposes.

5To exit the overlay, enter ****.

6Connect two telephones to either a phone line or a proper network connection, depending on the telephone type. Refer to the user guides specific to the telephones.

7Ensure that you have dial tone on both telephones, and check that you can dial one phone from the other.

—End—

Enabling card slots (LD 32)

If the MGATE card slots are not automatically provisioned, perform the following procedure to enable them.

Step Action

1Connect to the PBX.

2Enter LD 32.

3To display the status of the MGATE card, enter STAT n (where n is the card slot used by the MGATE).

For example: STAT 18.

4If the MGATE card is disabled, enter ENLC n (where n is the card slot used by the MGATE) to enable it.

For example: ENLC 18.

5Repeat steps 3 and 4 for each required MGATE card.

Nortel CallPilot

Quickstart Guide

NN44200-313 01.02 Standard

5.019 May 2008

Copyright © 2007-2008, Nortel Networks