8. Programmable Features
3.Press {1} to select “ON”.
4.Press {SET}.
5.Enter the transfer telephone number, up to 30 digits.
6.Press {SET}.
7.Press {MENU}.
{#}{6}{1} Checking, recording or erasing the transfer greeting message
CHECK [±]
{1} “CHECK” (default) {2} “RECORD”
{3} “ERASE”
See page 65 for details.
{#}{6}{7} Setting the incoming message monitor
ICM MONITOR
MODE=ON [±]
To hear an incoming message (ICM) from the speaker when the answering machine is recording the message.
{1} “ON” (default): You can monitor the incoming message.
{2} “OFF”: Deactivates this feature.
{#}{7}{0} Calling your pager
PAGER CALL
MODE=OFF [±]
{1} “ON”
{2} “OFF” (default) See page 65 for details.
{#}{7}{2} Setting flash time
SET FLASH TIME
MODE=700ms [±]
The flash time depends on your telephone exchange or host PBX.
{1} “90ms” {2} “100ms” {3} “110ms” {4} “250ms” {5} “300ms” {6} “400ms” {7} “600ms”
{8} “700ms” (default)
Note:
LIf the unit is connected via a PBX, PBX functions (transferring a call etc.) might not work correctly. Consult your PBX supplier for the correct setting.
LYou can also program this feature with the handset (page 76).
{#}{7}{5} Setting the Caller ID number auto edit feature
CALLER ID EDIT
MODE=ON [±]
{1} “ON” (default) {2} “OFF”
See page 42 for details.
{#}{7}{6} Setting the connecting tone
CONNECTING TONE
MODE=ON [±]
If you often have trouble when sending faxes, this feature allows you to hear connecting tones: fax tone, ring back tone and busy tone. You can use those tones to confirm the status of the other party’s machine.
{1} “ON” (default): You will hear connecting tones.
{2} “OFF”: Deactivates this feature.
Note:
LIf the ring back tone continues, the other party’s machine may not be a fax machine or may have run out of paper. Check with the
other party.
LThe connecting tone volume cannot be adjusted.
{#}{7}{7} Changing the receiving mode in the AUTO ANSWER setting
AUTO ANSWER
MODE=TAM/FAX [±]
{1} “TAM/FAX” (default): Telephone Answering Machine/Fax mode (page 52)
{2} “FAX ONLY”: Fax only mode (page 53)
{#}{8}{0} Resetting advanced features to their default settings
SET DEFAULT
RESET=NO [±]
{1} “YES”
{2} “NO” (default)
To reset the advanced features:
1.Press {MENU}.
2.Press {#}, then {8}{0}.
3.Press {1} to select “YES”.
4.Press {SET}.
5.Press {SET} again.
6.Press {MENU}.
73
