Paradyne 336x E1 manual Com IP Adr Next Edit Clear Prev, Com NetMask Next Edit Clear Prev

Configuration Options

Table C-9

(3 of 4)

General SNMP Configuration Options

Com IP Adr:

Next Edit Clear Prev

Com Port IP Address. Specifies the IP address for the communication port when it is configured as the SNMP management link. The IP address is only in effect when the Com Use configuration option is set to SNMP or Daisy.

Edit ± Allows you to edit or display the IP address for the communication port.

Clear ± Allows you to clear the IP address for the communication port. The IP address is set to 000.000.000.000.

Com NetMask:

Next Edit Clear Prev

Subnet Mask for the Communication Port. Specifies the subnet mask needed to access the unit when the communication port is configured as the SNMP management link. The subnet mask is only in effect when the Com Use configuration option is set to SNMP or Daisy.

Edit ± Allows you to edit and/or display the subnet mask for the communication port.

Clear ± Allows you to clear the subnet mask for the communication port. The subnet mask is set to 000.000.000.000. If the subnet mask is 000.000.000.000, the IP protocol creates a default subnet mask based on the class of the IP address (Class A: 255.000.000.000, Class B: 255.255.000.000, or Class C: 255.255.255.000).

Com Link: PPP

Next PPP SLIP Prev

Com Port Link Layer Protocol. Specifies the link layer protocol for the communication port when it is configured as the SNMP management link. This protocol is only in effect when the Com Use configuration option is set to SNMP.

PPP± Specifies PPP as the link layer protocol for the SNMP management link on the communication port.

SLIP ± Specifies SLIP as the link layer protocol for the SNMP management link on the communication port. The communication port must be configured for asynchronous operation to support SLIP. This selection does not appear if the Com Use configuration option is set to Daisy.

3360-A2-GB20-20 December 1996 C-19