Paradyne 336x E1 manual Displaying LED Conditions, Status Perf TStat LED, Select LEDs E1 Prt1 Prt2

ACCULINK 336x E1 NTU

Displaying LED Conditions

The same conditions monitored by the front panel LEDs can also be monitored by the LED command. This command is most useful when the E1 NTU is being accessed remotely (see Appendix G, Front Panel Emulation). When using Front Panel Emulation, no LEDs are shown on the PC's screen; you must use the Stat command procedure described below to get LED information.

NOTE

The following procedure is an example only. Screen displays may vary depending on the model of the E1 NTU.

To display LED conditions on the front panel screen,

1. From the top-level menu screen, select Stat.

E1 HDSL NTU

Stat	Test	Cnfig
F1	F2	F3

2.From the Status screen, press the key until the LED selection appears on the screen.

Status:
HDSL	DevHS STest
F1	F2	F3

3. From the Status screen, select LED.

Status:

Perf TStat LED

F1 F2 F3

4.From the Select LEDs screen, press the Function key that corresponds to E1 or the port for which you want to display LEDs. Use the scroll keys, if necessary.

Select LEDs:

E1 Prt1 Prt2

F1 F2 F3

If you chose E1, the LED Display screen lists the LED signals, two at a time, on the second line. A vertical bar at the left of the LED name indicates the condition is ON, while an underscore indicates the condition is Off.

LED Display:

_Test _NetSig1

F1 F2 F3

If you chose a port, the Port n LEDs screen lists the LED signals, two at a time, on the second line. A vertical bar at the left of the LED name indicates the condition is ON, while an underscore indicates the condition is Off.

Port n LEDs: _DTR _TXD

F1 F2 F3

5.Use the and keys to scroll LED names onto the screen.

3-10 December 1996 3360-A2-GB20-20