Paradyne 336x E1 manual Allocating Data Ports, Prt1, EditDTE Port, Net, Chan

ACCULINK 336x E1 NTU

8.If you selected NET the channels allocated to the network interface are displayed. Line 1 displays the 31 channels for the network interface, while Line 2 displays what is allocated to the DS0

channel shown in Line 1. Pressing the or key scrolls the channels onto the screen in groups of three.

N1	N2	N3
D2	D3	Prt1
F1	F2	F3

If you selected DTE, the channels allocated to the G.703 DTE interface are displayed. Line 1 displays the 31 channels for the G.703 DTE interface, while Line 2 displays what is allocated to the DS0 channel shown in Line 1.

D1	D2	D3
±	N1	N2
F1	F2	F3

Allocating Data Ports

By using the configuration options, assign a specific port to DS0 channels on either the network interface or the G.703 DTE interface. The following methods are available to assign DS0 channels to the port:

Block ± Allows a block of contiguous channels to be assigned by specifying a data port rate and an initial DS0 channel (the first DS0 channel in a block of DS0 channels). The number of channels assigned is determined by the port rate. Only those initial DS0 channel numbers that provide enough bandwidth (based on the port's data rate) are displayed on the screen. These channels are automatically assigned to the destination E1 interface (HDSL or G.703 DTE) when the initial DS0 channel is selected.

Chan ± Individually selects the DS0 channels to allocate to the data port. The data port rate is automatically determined based on the number of channels selected.

Once a port is selected, you have access to the configuration options to complete the port allocation procedure. These configuration options enable you to,

•Assign the selected port to the desired interface

•Select the desired method for channel allocation

•Select the port rate and starting channel (if the allocation method is block)

•Select the specific channels (if the allocation method is by individual channel)

These configuration options are explained in detail in Appendix C.

To select the data port,

1.From the top-level menu screen, select Cnfig.

2.Select the configuration option set to be copied into the Edit area by using the appropriate Function key. Use the scroll keys, if necessary.

3.Select Edit.

4.From the Edit screen, press the key until the Chan selection appears on the screen.

5.Select Chan.

Edit:DTE
Port	NET	Chan
F1	F2	F3

6.From the Channel Config screen, press the key to scroll the ports onto the screen.

Channel Config:

Dsply Clear DTE

F1 F2 F3

3-28 December 1996 3360-A2-GB20-20