Paradyne 336x E1 manual Transmission Group, MIB, Icmp Group, MIB, UDP Group, MIB, Snmp Group, MIB

SNMP MIB Objects

IP Group ± ªipRouteProtoº Object (ipRouteEntry 9)

This object is a read-only object and may have the following values in the E1 NTU.

•other(1) ± Temporary route added by IP.

•local(2) ± Route added or modified as a result of user configuration via the front panel.

•netmgmt(3) ± Route added or modified by means of an SNMP set.

•icmp(4) ± Route added or modified by Internet Control Management Protocol (ICMP).

•rip(8) ± Route added or modified by the Routing Information Protocol (RIP) or similar proprietary protocol.

Transmission Group, MIB II

Objects in the transmission group are supported on the network and G.703 DTE interfaces, the COM port, the AUX port, and the synchronous data ports. The objects in the transmission group are not defined within MIB II, but rather through other Internet standard MIB definitions. The following two transmission group objects are supported by the E1 NTU.

•ds1 (transmission 18) ± The transmission object supported on the E1 interfaces.

•rs232 (transmission 33) ± The transmission object supported on the synchronous data ports, COM port, and AUX port.

The ªds1º transmission object is defined by the DS1/E1 MIB. The rs232 transmission object is defined by the RS-232-like MIB.

IP Group ± ªipRouteAgeº Object (ipRouteEntry 10)

This object is implemented as a read-only object in the

E1 NTU. In the E1 NTU, it reflects the value of the route's time-to-live (in seconds). When displayed, a value of 999 represents a route that is retained permanently. For temporary routes, the ipRouteAge object decrements over time. All routes added via an SNMP set of the ipRouteTable are considered permanent routes. These routes do not age, but will remain unless deleted via SNMP.

ICMP Group, MIB II

The ICMP Group objects are fully supported by the E1 NTU.

UDP Group, MIB II

The User Datagram Protocol (UDP) Group objects are fully supported by the E1 NTU.

SNMP Group, MIB II

The SNMP Group objects that apply to a management agent are fully supported by the E1 NTU. The following objects apply only to an NMS and return a zero value if accessed.

•snmpInTooBigs (snmp 8)

•snmpInNoSuchNames (snmp 9)

•snmpInBadValues (snmp 10)

•snmpInReadOnlys (snmp 11)

•snmpInGenErrs (snmp 12)

•snmpInGetResponses (snmp 18)

•snmpInTraps (snmp19)

•snmpOutGetRequests (snmp 25)

•snmpOutGetNexts (snmp 26)

•snmpOutSetRequests (snmp 27)

•snmpOutGetResponses (snmp 28)

3360-A2-GB20-20 December 1996 E-7