Paradyne 336x E1 Entp Trap Enab Next Enab Disab Prev, Link Trap Both Next Disab Up Down Both Prev

ACCULINK 336x E1 NTU

Table C-10

(2 of 2)

SNMP Trap Configuration Options

Entp Trap: Enab

Next Enab Disab Prev

Enterprise Specific Traps. Specifies whether enterpriseSpecific traps are enabled. For more information, refer to the SNMP Traps section in Chapter 4, Maintenance.

Enab ± Sends trap messages for enterpriseSpecific events to the currently configured trap manager(s).

Disab ± Disables the sending of trap messages for enterpriseSpecific events.

NOTE: This configuration option is not available if the SNMP Trap configuration option (in the Alarm Configuration Options section) is disabled.

Link Trap: Both

Next Disab Up Down Both Prev

Link Trap Type. Specifies the link trap type to enable. Interfaces monitored for linkUp and linkDown traps are specified with the Trap I/F configuration option. For more information, refer to the SNMP Traps section in Chapter 4, Maintenance.

Disab ± Disables the sending of trap messages for linkDown or linkUp events.

Up ± Sends trap messages for linkUp events to the currently configured trap manager(s).

Down ± Sends trap messages for linkDown events to the currently configured trap manager(s).

Both ± Sends trap messages for linkUp and linkDown events to the currently configured trap manager(s).

NOTE: This configuration option is not available if the SNMP Trap configuration option (in the Alarm Configuration Options section) is disabled.

Trap I/F: All

Next NET DTE E1s Ports All Prev

Link Trap Interfaces. Specifies which interfaces generate linkUp and linkDown trap messages. These traps are supported on the E1 interfaces (network and G.703 DTE) and the synchronous data ports.

NET ± Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the network interface.

DTE ± Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the G.703 DTE interface. This selection is not displayed if the G.703 DTE interface is disabled.

E1s ± Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on either the network or G.703 DTE interface.

Ports ± Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the synchronous data ports.

All ± Sends trap messages for linkUp, linkDown, enterpriseTestStart, or enterpriseTestClear events occurring on the network interface, G.703 DTE interface, or the synchronous data ports.

NOTE: This configuration option is not available if the Link Trap configuration option is not configured to generate trap messages for linkUp or linkDown events.

C-22 December 1996 3360-A2-GB20-20