Paradyne 336x E1 manual Aux IP Adr Next Edit Clear Prev, Aux NetMask Next Edit Clear Prev

ACCULINK 336x E1 NTU

Table C-9

(4 of 4)

General SNMP Configuration Options

Aux IP Adr:

Next Edit Clear Prev

IP Address for the Auxiliary Port. Specifies the IP address needed to access the unit when the auxiliary port is configured as the SNMP management link. The IP address is only in effect when the Aux Use configuration option is set to SNMP or Daisy. The auxiliary port only supports the PPP link protocol.

Edit ± Allows you to edit and/or display the IP address for the auxiliary port.

Clear ± Allows you to clear the IP address for the auxiliary port. The IP address is set to 000.000.000.000.

Aux NetMask:

Next Edit Clear Prev

Subnet Mask for the Auxiliary Port. Specifies the subnet mask needed to access the unit when the auxiliary port is configured as the SNMP management link. The subnet mask is only in effect when the Aux Use configuration option is set to SNMP or Daisy.

Edit ± Allows you to edit and/or display the subnet mask for the auxiliary port.

Clear ± Allows you to clear the subnet mask for the auxiliary port. The subnet mask is set to 000.000.000.000. If the subnet mask is 000.000.000.000, the IP protocol creates a default subnet mask based on the class of the IP address (Class A: 255.000.000.000, Class B: 255.255.000.000, or Class C: 255.255.255.000).

Def Netwk: None

Next None Com Aux FDL EDL1 EDL2 EDL3 EDL4 Prev

Default Network Destination. Specifies the default network destination. This configuration option specifies where the default network is connected. For example, if the default network is connected to the communication port, you select Com. If the default network is connected to the far-end 33xx Series device over the FDL, you select FDL. The routing protocol uses the default network destination to route data that does not have a specific route.

None ± No default network destination. Data that cannot be routed is discarded.

Com ± The default network destination is the communication port. This selection only appears if the Com Use configuration option is set to SNMP.

Aux ± The default network destination is the auxiliary port. This selection only appears if the Aux Use configuration option is set to SNMP.

FDL ± The default network destination is FDL. This selection only appears if the FDL management link is enabled for SNMP.

EDLn ± For 2-port and 4-port E1 NTUs, the default network destination is the EDLn port (where n is 1±4). This selection only appears in 2-port and 4-port E1 NTUs if the synchronous data port's EDL management link is enabled for SNMP.

NOTE: If the chosen default network link is disabled or down, data is discarded. Return to this menu and choose another default network.

C-20 December 1996 3360-A2-GB20-20