Paradyne 3810 manual Remote Branch, Online Control Remote

COMSPHERE 3800 Series Modems

Remote Branch

The following conditions must be met before using the Remote branch:

•A connection using either the dial network or leased lines must be established.

•The Access from Remote configuration option must be enabled in the remote modem.

•The Remote Access Password configuration option must be the same for both the local and remote modems.

Remote DCP access is accomplished using either the primary or secondary channel (if available) of the VF line. Using the primary channel gives a much faster response time due to the higher data rate, but it also interrupts data flow because primary data is stopped when Remote mode is active. Once Remote mode is terminated, the primary channel is automatically made available to data transmission.

Unlike primary channel communications, the secondary channel operates at a slower data rate and does not interrupt data flow. (V.32bis and V.32 are the only modulations available on the secondary channel.)

To access the Remote branch, make the following selections:

Online : 19.2 <

Control Remote

F1 F2 F3

Press the key until Remote appears. Select Remote.

NOTE

If a connection is not established between a local 3800 Series modem and a remote 3800 Series modem, the LCD displays Remote Mode Fail ± No Circuit.

Press the key to return to the Top-Level menu and dial again.

Select Channel		>
Secondary
F1	F2	F3

or

Select Channel		<
Prim (data blckd)
F1	F2	F3

If operation over the secondary channel is desired, press any function key to select the secondary channel.

Secondary channel only appears if using V.32bis or V.32 modulation. If operation over the primary channel is

desired, press the key until Prim appears, and press any function key.

11-2 November 1996 3810-A2-GB30-20