Paradyne 3810 manual Change Directory

Call Setup Branch

Dial Standby

Command Complete

F1 F2 F3

If the modem is operating in a Dial Backup mode, the Dial Standby function forces the modem to leased lines and displays the status message Command Complete.

Once the modem is in Dial Standby mode, the Return to Dial function appears on the LCD. Selecting this function forces the modem to dial networks and displays the status message Command Complete.

AT Command Equivalent

There is no AT Command equivalent for Dial Standby or Return to Dial.

Change Directory

Change Directory allows you to enter or modify telephone numbers. The modem has nonvolatile memory locations that allow you to store up to 10 telephone numbers. Each directory location can accept up to

40 characters; this includes the telephone number and dial command modifiers. Any telephone number dialed using the DCP Dial command must appear in a directory location.

NOTE

If the modem is operating on leased lines and has a dial line attached for dial backup purposes, it is required that directory location 1 contain the telephone number used for dial backup.

To access Change Directory from the Call Setup branch, make the following selections:

Call Setup:		>
Change_Directory
F1	F2	F3

Press the key until Change_Directory is displayed. Press any function key to select Change_Directory.

01 : 5551234 ←
Nxt	"	#
F1	F2	F3

The phone number listed in directory location 1 is displayed. Select Nxt to display other directory locations.

Entering Telephone Numbers and Dial Command Modifiers into Directory Locations

The following example uses an empty directory location for describing how to enter a telephone number. If you want to change an existing telephone number in any of the ten directory locations, follow the same procedures.

To add a telephone number to a directory location, make the following selections:

02 : z

Nxt￿￿￿￿" #

F1 F2 F3

Select Nxt until a blank directory appears on the LCD. (The cursor ( { ) always appears in the first character position.)

Select F2 (") or F3 (#) until the desired character is selected. This can be an alpha or numeric character.

02 : 9 z

Nxt￿￿￿￿" #

F1 F2 F3

Press the key to move the cursor to the next character position.

Continue this key sequence until the dial command modifiers and telephone number are entered. (Refer to Table 5-1 for a list of valid dial command modifiers.)

3810-A2-GB30-20 November 1996 5-5