Paradyne 3810 manual Dial Backup Indicates Messages, Firmware Indicates Download Result Messages

COMSPHERE 3800 Series Modems

	Table 4-4
	(3 of 3)
	Top-Level Menu Status
Dial Backup	Indicates
Messages
Dial Standby	The modem is operating in Dial Standby mode.
DialBckUp:MR*	The modem is operating in a Dial Backup mode at the displayed data rate and is configured for
	Direct mode.
Backup:MR* EC**	The modem is operating in Dial Backup mode and is configured for error control and data
	compression on leased lines.
Stndby:MR* EC**	The modem is operating in Dial Standby mode and is configured for error control and data
	compression on leased lines.
Firmware	Indicates
Download Result
Messages
DownldOnly Mode	Indicates that a local download of firmware or a remote cloning of firmware has failed. The
	modem is currently in a Download Only mode in which only another download attempt is possible.
Frmware Upgrade	Indicates that a local download of firmware or a remote cloning of firmware was successful.
RemClone Failed	Displays on the local modem's LCD and indicates that a remote cloning of firmware has failed.
Remote Clone OK	Displays on the local modem's LCD and indicates that a remote cloning of firmware was
	successful.
AT Command	Indicates
Reset Message
Reset by AT	The modem has performed a reset in response to an ATZ command.
command

* MR. Modem Rate indicates the data rate the modem is using. One of the following values appears: 300, 1200, 2400, 4800, 7200, 9600, 12K (12,000), 14.4 (14,400), 16.8 (16,800), or 19.2 (19,200) bps.

** EC. Error Control indicates the modem is online and using V.42 or MNP error control. One of the following values appears after the modem rates listed above: MNP2, MNP3, MNP4, MNP5, V42, V42b, or NoEC. (NoEC indicates the modem is connected in Buffer mode rather than error control. If an EC value does not appear, then the modem is in Direct mode.)

4-10 November 1996 3810-A2-GB30-20