Paradyne 3810 manual Straps When Disconnected, ARQ Window Size Increase, DTE Rate = VF Rate

COMSPHERE 3800 Series Modems

S-Register

Table 14-2

(11 of 11)

3800 Series S-Registers

Description Front Panel Branch

S88	Straps When Disconnected			Configure\Edit\V.42/MNP/
	Register determines whether the Active(Operating) area is reloaded			Buffer
	upon a disconnect.
	Register has the following values:
	0	(or 231)	= No Change
	1	(or 232)	= Reload
	2	(or 233)	= Reload with no AT Change

Factory setting is No Change.

S89	V.42 ARQ Window Size Increase		None
	Register allows the V.42 Automatic Request for Transmission (ARQ)
	window size to be set to a value from 6 to 15 frames to accommodate
	satellite delays.
	Register has the following values:
	0 for 6 frames (default)
	1 for 7 frames
	2 for 8 frames
	3 for 9 frames
	S	S
	S	S
	9 for 15 frames
	This command applies only to connections made using V.42bis data
	compression or V.42 error control.
	Factory setting is 6 frames.
S90	DTE Rate = VF Rate		Configure\Edit\Misc
	Register forces the DTE (computer) data rate to be equal to the VF
	(telephone line) data rate.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.
S91	Cellular Enhancements		Configure\Edit\Misc
	Register determines whether parameters are set to improve performance
	over a cellular link. Should be enabled when the remote modem is using
	a cellular connection.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.
S93	RJ11 Cellular Adapt		Configure\Edit\Misc
	Register controls support for an RJ11 connection, including generation of
	the ETC 1.1 Calling Tone during call origination.
	Register has the following values:
	0 = Disable
	1 = Enable
	Factory setting is Disable.

14-26 November 1996 3810-A2-GB30-20