Paradyne 3810 manual Dial Transmit Level Type, Leased Mode

AT Command Set and S-Registers

		Table 14-1
		(7 of 12)
		3800 Series AT Commands
AT		Description	Front Panel
Command			Branch
&I	Dial Transmit Level		Configure\Edit\Dial Line
	When Dial Transmit Level Type is set to Permissive, &In sets Dial Transmit
	Level to a value between ±10 and ±32 dBm. &I99 and &I100 cause the level to
	be varied automatically according to conditions for Enhanced Throughput
	Cellular (ETC) operation.
	&I10	±10 dBm
	&I11	±11 dBm
	S	S
	S	S
	&I32	±32 dBm
	&I99	Automatically adjusted according to the ETC1.0 specification. Use only
		with remote modems set to &I99, and limit the data rate to 4800 bps
		(S41 = 5). Set by &F6.
	&I100 Automatically adjusted according to the ETC1.1 specification.
	NOTE: &J0 overrides this command; &In overrides the &J0 command.
&Jn	Dial Transmit Level Type		Configure\Edit\Dial Line
	&J0	Permissive (Approx. ±9 dBm).
	&J1	Programmable
	NOTE: &Jn overrides the &In command.
&Ln	Leased Mode		Configure\Edit\Leased
	&L0	Disables leased-line operation.	Line
	&L1	2-wire originate leased-line operation.
	&L2	4-wire originate leased-line operation (Model 3810 and 3811 only).
	&L3	2-wire answer leased-line operation.
	&L4	4-wire answer leased-line operation (Model 3810 and 3811 only).
	The &L command will cause the modem to reset before entering or exiting
	Leased-Line mode. Therefore, it must be entered as the last command in an
	initialization string.

3810-A2-GB30-20 November 1996 14-9