Paradyne 3810 ReprogramRemote, RemClone Status Establish Remote, RemClone Status Initializing

Control Branch

At this point, if you do not want to continue this process, abort the transfer by selecting any function key. This returns the modem to the Top-Level menu.

However, to continue with the transfer, press the key to display the Reprogram_Remote selection.

Warning : Download

Reprogram_Remote

F1 F2 F3

Press any function key to begin the transfer.

RemClone Status

Establish Remote

F1 F2 F3

The local modem's LCD displays Establish Remote, indicating the modem is attempting to establish a Remote Cloning Download session with the remote modem.

If unsuccessful, the modem remains in the Download Transfer mode. The LCD's top line displays RemClone Failed and the bottom line displays one of the following messages:

Incompat The modems are connected,

Modulat but are using a modulation scheme other than V.33, V.32bis, V.32, or V.29.

No Response The remote modem is not a 3800 Series modem or the connection between the two modems is poor.

Access	The remote modem's Access
Disabled	from Remote configuration is
	disabled. Also is displayed if
	the local modem has a
	firmware release prior to
	Release 3.0 and the remote
	modem has Release 3.0 or
	greater installed with either
	Answer Access Security or
	Originate Access Security
	enabled. In this case, both
	security methods must be
	disabled in the remote modem
	to achieve the download.
Password	The local and remote
Invalid	modems' passwords do not
	match.

Correct the problem and attempt another download from the local modem. If this fails, contact your service representative.

After successful establishment of a Remote Cloning Download session, the following screens are displayed.

RemClone Status

Initializing

F1 F2 F3

RemClone Status

Bank 1 : xxxx/yyyy

F1 F2 F3

3810-A2-GB30-20 November 1996 10-5