Paradyne 3810 25bis Coding, 25bis Idle Character, 25bis New Line Character, NMS Call Messages

AT Command Set and S-Registers

S-Register

Table 14-2

(8 of 11)

3800 Series S-Registers

Description Front Panel Branch

S62	V.25bis Coding		Configure\Edit\DTE Dialer
	Register identifies to the modem the type of coding used by the DTE
	while in V.25bis mode.
	Register has the following values:
	0	= ASCII
	1	= EBCDIC
	Factory setting is ASCII.
S63	V.25bis Idle Character		Configure\Edit\DTE Dialer
	Register identifies to the modem the type of idle fill used by the DTE
	while in V.25bis mode.
	Register has the following values:
	0	= Mark
	1	= Flag
	Factory setting is Mark.
S64	V.25bis New Line Character		Configure\Edit\DTE Dialer
	Register identifies to the modem the type of line terminator used by the
	DTE while in V.25bis mode.
	Register has the following values:
	0	= Carriage Return and Line Feed
	1	= Carriage Return
	2	= Line Feed
	Factory setting is carriage return and line feed (CR + LF).
S65	Line Current Disconnect		Configure\Edit\Line Dialer
	Register determines if the modem disconnects if an 8-millisecond or
	90-millisecond interruption in loop current occurs.
	Register has the following values:
	0	= Enable (8msec)
	1	= Enable (90msec)
	2	= Disable

Factory setting is Enable (8msec).

S66	NMS Call Messages		Configure\Edit\Misc
	Register determines if the modem sends information regarding status
	(Call Progress) and/or sends summarized call statistics (Call Connect) to
	the network management system (COMSPHERE 6700 Series NMS).
	Register has the following values:
	0	= Call Connect & Progress
	1	= Disable
	2	= Call Connect Only
	3	= Call Progress Only
	Factory setting is Call Connect & Progress.
S67	Directory Location 1 Callback		Configure\Edit\Misc
	Register determines if the modem uses the single number callback
	function.
	Register has the following values:
	0	= Disable
	1	= Enable
	Factory setting is Disable.

3810-A2-GB30-20 November 1996 14-23