Paradyne 3810 manual Flow Control of DTE, Flow Control of Modem, No Data Disconnect Timer, X0

AT Command Set and S-Registers

Table 14-1

(11 of 12)

3800 Series AT Commands

AT				Description	Front Panel
Command					Branch
\Qn	Flow Control of DTE, Flow Control of Modem				Configure\Edit\
					V42/MNP/Buffer
			Flow	Flow
			Control	Control of
			of DTE	Modem
		\Q0	Disable	Disable
		\Q1	XON/XOFF	XON/XOFF
		\Q2	CTS to DTE	Disable
		\Q3	CTS to DTE	RTS to Mdm
		\Q4	XON/XOFF	Disable
		\Q5	Disable	XON/XOFF
		\Q6	Disable	RTS to Mdm
\Tn	No Data Disconnect Timer				Configure\Edit\Line
	\T0	Disable.			Dialer
	\Tn Where n is a value from 1 to 255 in 1-minute increments.
\Xn	XON/XOFF Passthrough Flow Control				Configure\Edit\
	\X0	Disable.			V42/MNP/Buffer
	\X1	Enable.
%An	Error Control Fallback Character				Configure\Edit\
	%An Where n is an ASCII value from 0 to 127. Factory default is 013 ASCII.				V42/MNP/Buffer
%Bn	Modulation and Data Rate
	Sets the modulation and maximum VF rate.
	The %B300 and %B1200 commands work in conjunction with the B (CCITT/
	Bell Mode) command to determine modulation.
	%B19200		V.32terbo, maximum rate 19,200 bps
	%B16800		V.32terbo, maximum rate 16,800 bps
	%B14400		V.32bis, maximum rate 14,400 bps
	%B12000		V.32bis, maximum rate 12,000 bps
	%B9600		V.32bis/V.32, maximum rate 9600 bps
	%B7200		V.32bis, maximum rate 7200 bps
	%B4800		V.32bis/V.32, maximum rate 4800 bps
	%B2400		V.22bis. maximum rate 2400 bps
	%B1200		V.22 or Bell 212A, maximum rate 1200 bps
	%B300		V.21 or Bell 103, maximum rate 300 bps

3810-A2-GB30-20 November 1996 14-13