Paradyne 3810 manual Originate Access Security, Answer Access Security

COMSPHERE 3800 Series Modems

Originate Access Security

Originate Access lets you control who can originate a call from a local modem via the AT command set. This is useful in LAN and modem pooling applications. With Originate Access security, a local user's password is embedded in the AT dial command. If the password is valid, the user can dial out using this modem.

The following example illustrates the format for an Originate Access password:

TYPE: ATD%abc123%T9,8005551234

PRESS: Enter

Where: ATD is the AT dial command string.

Percent (%) is the start and stop AT command string interrupt character. The password must be embedded in these characters.

abc123 is the 10-alphanumeric character originate passwords.

T is the Tone (DTMF) dial modifier.

Comma (,) is the pause dial modifier.

98005551234 is the phone number.

Originate Access Security is enabled or disabled by the Set Originate Security group.

Answer Access Security

The other method of security, which is the primary focus of this chapter, is Answer Access. Answer Access allows the answering modem to restrict entry to the host DTE by ensuring that originating (remote) modems and/or users have been granted proper security access. Access can be granted by using one of three techniques: VF-side password entry, DTE-side password entry, or a combination of both.

VF-Side Passwords

VF-side password entry occurs between modems prior to connecting. Once the VF-side password is entered, no other user intervention is required since security negotiation is handled solely by the modems. When the answering modem is configured for VF entry technique, it goes off-hook and transmits to the originating modem either a secondary dial tone or silence (this choice depends on how the VF Prompt Type option is configured). The originating modem detects this response and transmits its password which corresponds to a preselected series of DTMF tones. Note that VF passwords can be from 1 to 8 digits in length; only decimal digits are permitted. The answering modem verifies the password against its own password database, and if valid, continues with the normal training sequence.

VF-side password works with any autodialer that supports second dial tone or quiet answer and can be implemented in one of three ways. First, the VF password can be embedded within the AT command dial string. Second, a phone number and password can be entered via the diagnostic control panel (DCP). (This is the preferred method for synchronous applications.) And finally, an attached telephone can be used to manually generate DTMF tones for the phone number and password. After the answering modem accepts the password and generates an answerback tone, the originating caller places the modem in Data mode and hangs up the phone.

The following examples illustrate two ways to enter a VF-side password:

TYPE: ATDP5551234TW12345678#

or

ATDT5551234@12345678#

PRESS: Enter

Where: ATD is the AT dial command.

P and T are the Pulse dial and Tone (DTMF) dial modifiers.

5551234 is the phone number.

W or @ is the VF Prompt Tone option setting for second dial tone or quiet answer.

12345678 is the VF-side password.

#is the password termination character.

12-2 November 1996 3810-A2-GB30-20