Paradyne 3810 manual No Data Disconnect Trigger Signal, 32bis Autorate Leased Line, MI/MIC Dialing

AT Command Set and S-Registers

S-Register

Table 14-2

(10 of 11)

3800 Series S-Registers

Description Front Panel Branch

S80	No Data Disconnect Trigger Signal		Configure\Edit\Line Dialer
	Register determines whether Pin 2 (transmit data) or Pin 3 (receive data)
	of the modem's RS-232 serial interface is monitored so that the modem
	can disconnect the call if there is no activity for a certain period. (See the
	\T command.)
	Register has the following values:
	0	= Transmit or Receive
	1	= Transmit only
	2	= Receive only
	3	= Transmit and Receive
	Factory setting is 3.
S82	V.32bis Autorate (Leased Line)		Configure\Edit\Leased Line
	Register determines if Autorating is used on leased lines when
	connected in V.32bis mode.
	Register has the following values:
	0	= Enable
	1	= Disable
	Factory setting is Enable.
S83	MI/MIC Dialing		Configure\Edit\Line Dialer
	Register determines if MI/MIC control leads can be used to force the
	modem into the originate handshake after first dialing a call.
	Register has the following values:
	0	= Disable
	1	= Enable
	Factory setting is Disable.
S84	AT Command Mode		Configure\Edit\DTE Dialer
	Register determines how the modem responds to valid and invalid AT
	commands.
	Register has the following values:
	0	= Normal
	1	= No ERROR
	2	= No Strap or ERROR
	Factory setting is Normal.
S85	Fast Disconnect		Configure\Edit\Line Dialer
	Register allows the modem to disconnect immediately after receiving a
	disconnect command from a local DTE or its own diagnostic control
	panel.
	Register has the following values:
	0	= Disable
	1	= Enable
	Factory setting is Disable.

3810-A2-GB30-20 November 1996 14-25