Paradyne 3810 manual Async/Sync Mode and DTE Dialer Type, M0, &Q0, RTS Action, DSR Control

COMSPHERE 3800 Series Modems

Table 14-1

(8 of 12)

3800 Series AT Commands

AT			Description	Front Panel
Command				Branch
&Mn	Async/Sync Mode and DTE Dialer Type			Configure\Edit\DTE
and &Qn	&M0, &Q0		Modem operates in Asynchronous mode and uses	Dialer
			AT Command protocol.
	&M1, &Q1		Modem operates in Synchronous mode and uses
			AT Command protocol.
	&M2, &Q2		Modem operates in Synchronous mode and dials telephone
			number stored in directory location 1 when DTR signal turns
			Off and then ON.
	&M3, &Q3		Modem operates in Synchronous mode and uses
			AT Command protocol.
	&Q4		Modem operates in Asynchronous mode and uses
			AT Command protocol; Hayes AutoSync is enabled.
	&M231, &Q231		Modem operates in Asynchronous mode; the DTE
			Dialer Type is disabled.
	&M232, &Q232		Modem operates in Asynchronous mode; V.25bis Async
			dialing is enabled.
	&M233, &Q233		Modem operates in Synchronous mode; V.25bis Bisync
			dialing is enabled.
	&M234, &Q234		Modem operates in Synchronous mode; V.25bis HDLC
			dialing is enabled.
	&M235, &Q235		Modem operates in Asynchronous mode; AT&T
			Exclusive dialing is enabled.
	&M236, &Q236		Modem operates in Synchronous mode; the DTE Dialer
			Type is disabled.
	The &M2, &Q2, &M231, &Q231, &M236, and &Q236 commands disable the
	use of AT commands and force the modem into Dumb mode. The only way to
	gain control of the modem is the front panel.
&Rn	RTS Action			Configure\Edit\DTE
	&R0	Standard RS232.		Interface
	&R1	Ignores RTS.
	&R2	Simulated Control Carrier.
&Sn	DSR Control			Configure\Edit\DTE
	&S0	Forced On.		Interface
	&S1	Standard RS232.
	&S2	Wink When Disconnect.
	&S3	Follows DTR.
	&S4	On Early.
	&S5	Delay to DTE.
	&S6	Dial Backup Toggle.

14-10 November 1996 3810-A2-GB30-20