AT Command Set and S-Registers

Table 14-1

(5 of 12)

3800 Series AT Commands

AT

 

Description

Front Panel

Command

 

Branch

 

 

 

 

 

&Cn

LSD Control

Configure\Edit\DTE

 

&C0

Forced On. LSD on at all times.

Interface

 

&C1

Standard RS232. LSD is on when the remote modem's carrier signal is

 

 

 

detected. LSD is off when carrier signal is not detected.

 

 

&C2

Wink When Disconnect. LSD normally forced ON, turns Off for

 

 

 

approximately one second upon disconnecting.

 

 

&C2

Wink When Disconnect. LSD normally forced ON, turns Off for

 

 

 

approximately one second upon disconnecting.

 

 

&C3

Follows DTR. State of LSD follows state of DTR.

 

 

&C4

Simulated Control Carrier. State of LSD follows state of remote modem's

 

 

 

RTS.

 

 

&C5

=DTR/Disconnect Off. State of LSD follows state of DTR except upon a

 

 

 

disconnect where DTR remains ON and LSD turns Off. DTR must then

 

 

 

toggle Off and ON to turn LSD ON. Use this setting for AT&T DATAKIT

 

 

 

applications. Note that to use this option, the DTR Action configuration

 

 

 

option must be set to Stndrd_RS232 (&D1 or &D2).

 

 

&C6

Bridge Retrain. LSD behaves as if it were set for Stndrd_RS232, except

 

 

 

that it is turned off when a retrain condition lasts longer than 10 seconds,

 

 

 

and turned on again when no retrain condition is detected for a period of

 

 

 

10 seconds.

 

 

 

 

&Dn

DTR Action

Configure\Edit\DTE

 

&D0

Ignore. Modem ignores the true status of DTR and treats it as always

Interface

 

 

ON.

 

 

&D1

Off=Command Mode. Modem enters online Command Mode if

 

 

 

connected when DTR switches Off.

 

 

&D2

Standard RS232. DTR Signal is controlled by the DTE.

 

 

&D3

Off=Reload Strap. Follows Standard RS232 operation, except that when

 

 

 

DTR switches Off, the modem loads the Active (Saved) area into the

 

 

 

Active (Operating) area.

 

 

&D4

Controls On-Hook. Follows Standard RS232 operation, except that

 

 

 

modem does not disconnect until DTR is lowered by the DTE.

 

 

&D5

Controls TX Mute. Follows Standard RS232 operation, except that when

 

 

 

DTR is lowered at the answering modem, the modem mutes transmitter

 

 

 

output.

 

 

 

 

&Fn

Select Factory Default Configuration Options

Configure\Factory

 

Loads factory configuration options into Active (Operating) area.

 

 

&F0

Async Dial

 

 

&F1

Sync Dial

 

 

&F2

Sync Leased: Answer

 

 

&F3

UNIX Dial

 

 

&F4

Sync Leased: Originate

 

 

&F5

Cellular (Mobile)

 

 

&F6

Cellular (PSTN)

 

 

 

 

 

3810-A2-GB30-20

November 1996

14-7

Page 141
Image 141
Paradyne 3810 manual LSD Control, DTR Action, Select Factory Default Configuration Options