Paradyne 3810 manual Series AT Commands Description Front Panel Branch, Result Code Format

COMSPHERE 3800 Series Modems

Table 14-1

(4 of 12)

3800 Series AT Commands

AT				Description			Front Panel
Command							Branch
Vn	Result Code Format						Configure\Edit\DTE
	V0		Displays result codes in Number (1) format digits.				Dialer
	V1 Displays result codes as text.
	V2 Displays result codes in Number (2) format (digits).
Xn	Extended Result Code, Dial Tone Detect, and Busy Tone Detect						Extended Result Code:
	Configuration Options						Configure\Edit\DTE
							Dialer
			Ext	Dial Tone	Busy Tone		Dial Tone Detect:
			Result Code	Detect		Detect	Configure\Edit\Line
							Dialer
		X0	Disable	Disable		Disable
							Busy Tone Detect:
		X1	Enable	Disable		Disable
							Configure\Edit\Line
		X2	Enable	Enable		Disable
							Dialer
		X3	Enable	Disable		Enable
		X4	Enable	Enable		Enable
		X5	Add/EC	Enable		Enable
		X6	Add/V42,MNP	Enable		Enable
		X7	Use DTE Rate	Enable		Enable
	EXTENDED RESULT CODE
	Enable. Displays all result codes listed in Table B-1 except for error control
	suffix.
	Disable. Only displays OK, CONNECT, RING, NO CARRIER, ERROR.
	Add/EC. Displays result codes with /EC suffix. Add/V42,MNP. Displays result
	codes with either V.42 or MNP suffix. Use DTE Rate. Displays DTE data rate
	instead of line rate.
	Add/V42,MNP. Displays result codes with either V.42 or MNP suffix.
	Use DTE Rate. Displays DTE data rate instead of line rate.
	DIAL TONE DETECT
	Enable. Sets the modem for dial tone detect.
	Disable. Sets the modem for blind dialing.
	BUSY TONE DETECT
	Enable. Modem monitors for busy tone.
	Disable. Modem ignores busy tone.
Yn	Long Space Disconnect						Configure\Edit\Line
	Y0		Disable. Ignores long space.				Dialer
	Y1 Enable. Disconnects if long space is detected. Enables transmission of a
			long space.
Zn	Reset and Load Active						Control\Reset
	Z0		Loads configuration options from Active (Saved) to Active (Operating).
	Z1		Loads configuration options from Customer 1 to Active (Operating).
	Z2		Loads configuration from Customer 2 to Active (Operating).
	Z3		Loads configuration options from Active (Saved) to Active (Operating)
			and performs a ªsoftº reset (if the modem is connected, it is
			disconnected).
	Z9		Performs a full modem reset, as if the power were turned off and on.

14-6 November 1996 3810-A2-GB30-20